110-300-0165(2)(d) · An early learning provider must take steps to prevent hazards to children including, but not limited to: (d) Making inaccessible to children plastic bags and other suffocation hazards;

110-300-0165(2)(d) at the time of the visit there was two ziploc plastic bags accessible in the personal cubbies.

Open Not marked corrected in the state record

Open / not marked corrected.

110-300-0145(11) · Prior to licensing, exiting mechanisms on gates from a licensed outdoor play area to unlicensed space must be equipped with a self-closing and self-latching mechanism (shuts automatically when released from an individual’s control). A gate that is not an emergency exit must be locked or self-closing and self-latching.

0145(11) la puerta de afuera le falta ajustar el cerrarse sola automaticamente. WAC/RCW Correction Date Disputed Date Disputed 110-300-0146(1)(a)(b) Serious 06/05/2024

Open Not marked corrected in the state record

Open / not marked corrected.

110-300-0146(1)(a)(b) · Non-Compliances: This section of the Inspection Report lists non-compliances found during any licensing inspection. Information from this section will be reported to Child Care Check and be can be used to determine current and future licensing and enforcement actions. Playground equipment and surfacing used by an early learning provider must comply with applicable CPSC guidelines, as now and hereafter amended including, but not limited to, installing, arranging, designing, constructing, and maintaining outdoor play equipment and surfacing. (a) Climbing play equipment must not be placed on or above concrete, asphalt, packed soil, lumber, or similar hard surfaces;(b) The ground under swings and play equipment must be covered by a shock absorbing material (grass alone is not an acceptable) such as: (i) Pea gravel at least nine inches deep; (ii) Playground wood chips at least nine inches deep; (iii) Shredded recycled rubber at least six inches deep; or (iv) Any material that has a certificate of compliance, label, or documentation stating it meets ASTM standards F1292.